Nokia mobile phone battery

We supply huge range of NOKIA mobile phone batteries packs and chargers for your mobile phone.All type of batteries in our website are made with high quality cells.1508i, 1680 classic, 2116i, 2300, 2310, 2323 Classic, 2660, 2680 slide, 2875i, 3100, 3109 Classic, 3110 Evolve, 3120, 3250 XpressMusic, 3395, 6210N, 6220 classic, 6600 slide, 6610i, 6620, 6710 Navigator,6720 Classic, 6820i, 6822, 7070 Prism, 7088, 7100 Supernova, 7210c, 7250, 7250i, 7260, 7270, 7310c, 7610 Supernova, 7700, 7710, 8390, 8600 Luna, 8800, 8800 Arte, 8800 Carbon Arte, 8800 Sapphire Arte, 8800 Sirocco, 8800a ,8855 ,8910i ,9300i,9500, E50 , E61i, E66, E70, E75, E90 Communicator, N-Gage, N-Gage QD,N70, N800, N810, N90, X02NK.
How to change the LCD of your Nokia mobile phone
step 1 What you will need:
A Nokia mobile.
A new LCD.
A T6 Torx-Screwdriver
step 2 Prepare the phone
Open the battery case by sliding the hood downwards. Remove the battery and if you want the sim card, too.Now you can see two screws on the end of the phone. Unscrew and remove them.
step 3 Remove the front case.
After you have removed the 2 screws you can remove the front case and keypad by carefully sliding the battery case hood between phone body and front case. Look at the pics, they will make it easier to understand.
step 4 Get the board out of the phone body.
Now you got to get out the board with the LCD on it. Out of the phone body.
step 5 Remove the LCD.
The LCD is attached to the board with a frame. The frame is attached to the board by two clamps and the connection cable from LCD to the board. The cable is covered by a hood that is also fused with a clamp to the board.Step by step.1. loosen the clamps on the sides of the board2. remove the frame by lifting it up and pull them over the side of the board (upwards)3. remove the upper cap that holds the connection LCD-board4. lift up the LCD and unplug the connection from the board. It should be easy, but if not use carefully some more strength.
step 6 Attach the new LCD and assemble your phone.
Now you have to connect the new, shiny LCD to the board.To do this, press the connecting plug onto the jack on the board. Move around until it fits, then press. It could be, that you have to press a bit harder than expected. But as always be careful.